Changing the Punch

1. Loosen the activating lever and lower
    jaw mounting nuts
    Do not remove the nuts

2. Rotate stop (A) full over
    Then rotate lever (B) full over

3. Pull Lever (B) to separate the gears

4. Lift the intermediate (D) to remove the
     punch (E)

5. To perform Step 5 the teeth of lever
    (B) must fit into intermediate (D) as
     shown (Side link and mounting nuts
     shown removed
     Do not remove bolts or sidelink

6. Re-engage gears by slowly lifting lever
    (B) back into teeth of gears on
     intermediate (D)
    Gears must mesh simultaneously

7. Rotate stop (A) and lever (B) back into
    position and re-tighten nuts (C)